conger.blogg.se - Hard wipe macbook pro

These issues can present themselves as lost or damaged files, slowness/sluggishness or random errors.

There are quite a few common reasons to restore your Mac to factory settings, the most common is due to issues with the file system. Common Reason for Restoring Mac to Factory Settings It is even possible to recover full partitions with Disk Drill if your Mac was repartitioned after a factory reset. While it is often considered to be a permanent deletion of data this is not always the case, Disk Drill is capable of recovering data after a factory reset. The main two things that occur are a full hard drive format and a reinstallation of macOS / Mac OS X.Ī format of the hard drive will erase all data on the hard drive and remove it from your iMac, MacBook Pro or Mac Mini. When you reset your Mac to factory settings you are essentially performing a series of low-level operations behind the scenes. If you find yourself needing to erase the contents of your hard drive and start fresh you can do so in just a few quick steps. You may be ready to sell your Mac or it may just be slow due to many years of use. Hold these keys until your Mac loads the Recovery Assistant.There are many reasons to reset your Mac to factory settings.

If your Mac uses an Intel processor, press the power button once and immediately hold the Command + R keys.

Wait for another 10 seconds before proceeding to step #2.

Hold down your Mac’s power button for about 10 seconds until it shuts down completely.

If you’re using an Intel-based Mac, reset its NVRAM and unpair Bluetooth devices before performing a factory reset. You need to boot into macOS Recovery to factory reset your Mac using Disk Utility. Of course, you can also use the tool to reset Apple Silicon Mac computers running macOS Monterey.

Factory Reset Mac Using Disk Utilityĭisk Utility is the best tool to factory reset Intel-based Mac computers running macOS Big Sur or older. Follow the Setup Assistant’s instructions to set up your Mac from scratch. Wait for a few minutes and connect your Mac to the internet (via Wi-Fi or Ethernet) when a “Hello” message appears on the screen. Your Mac will shut down, come back on, and display a progress bar.